PRIVACY POLICY
Saul Mineroff Electronics, Inc. (SME)
VCS Client & VCS FieldLink
Privacy Policy Updated: 10/29/2026
|
The VCS Client and VCS FieldLink
mobile apps are developed and published by Saul Mineroff
Electronics, Inc. (SME), a United States Corporation.
SME
respects your privacy rights and recognizes the importance of
protecting information, if any, collected about you. This Privacy
Policy defines how SME collects and uses personal and non-personal
information in relation to the applications ("apps") VCS Client and
VCS FieldLink. Where a practice applies to only one app, that app
is named.
VCS FieldLink is a support tool used by authorized
service technicians to give SME support staff temporary, remote
access to a VCS device's management interface while the technician
is on site.
BY INSTALLING, USING OR OTHERWISE ACCESSING
THESE APPS, YOU AGREE TO THIS PRIVACY POLICY. IF YOU DO NOT AGREE
TO THIS PRIVACY POLICY, PLEASE DO NOT INSTALL, USE OR OTHERWISE
ACCESS VCS Client OR VCS FieldLink. SME reserves the right to
modify this Privacy Policy at reasonable times, therefore please
review it frequently. If SME makes material or significant changes
to this Privacy Policy, SME will notify you by updating this page
and its "Updated" date, and where possible by a notice within the app. Your continued use of the app will signify your
acceptance of the changes to this Privacy Policy.
Personal Data:
SME does not collect or use any personal
data that may be used to identify or contact you, without your
consent. SME does not collect or use names, passwords, email
addresses, photos, video, account names, account numbers or other
information that would enable SME to identify you or the systems
which these apps connect to, except for the VCS device identifier
and session records that VCS FieldLink needs to provide support,
as described under "VCS FieldLink Support Connection" below. If an app uses third party services
for sharing Content generated using the app, the app would access
your basic data from such third party services needed for the
authentication, content sharing or other features provided by the
third parties, however, the app would not collect or use any
personal data.
Location and Wi-Fi Information:
Our
apps handle location differently, depending on the app.
VCS
FieldLink. VCS FieldLink requests location and nearby-Wi-Fi
permissions (on Android, ACCESS_FINE_LOCATION and
NEARBY_WIFI_DEVICES; on iOS, "while using the app" location access)
for a single purpose: to read the name (SSID) of the Wi-Fi network
your phone is connected to, so the app can identify the VCS device
being serviced. VCS FieldLink uses these permissions only to read
the Wi-Fi network name. It does not use GPS, does not determine or
track your geographic location, and does not collect, store, share
or transmit location data. Android and iOS require a location
permission to make the connected Wi-Fi network name available,
which is why the permission is requested even though no location
data is collected. VCS FieldLink does not use location in the
background and does not request "always" location access.
VCS Client. VCS Client may collect
approximate (coarse) location as part of non-personal usage
analytics, no more precise than a general metropolitan area, as
described under "Non-personal data" below. This is not used to
identify you.
Mobile Device Access:
We may request
access or permission to certain features of your mobile device.
VCS Client may request access to your device's storage, camera and
similar features. VCS FieldLink requests network and Wi-Fi
permissions so it can maintain, at the same time, an encrypted
connection to SME's relay server over cellular data and a
connection to the VCS device over its local Wi-Fi. To keep a
support session from being interrupted, on Android VCS FieldLink
runs a foreground service, may hold a wake lock, and displays a
notification while a session is active. On iOS, VCS FieldLink keeps
the screen on while a session is active (you can turn this off, and
optionally dim the screen, in the app); a session on iOS pauses if
you lock the phone or leave the app for more than about 30 seconds,
and resumes when you return to the app.
If you wish to change our access or permissions, you may do so in
your device's settings.
Push Notifications:
We may
request to send you push notifications regarding your account or
certain features of the app. If you wish to opt-out from receiving
these types of communications, you may turn them off in your
device's settings.
Live Video (VCS Client):
VCS
Client has the ability, at your discretion, to use the device's
onboard camera to send live video to an SME server which you
specify in the app’s configuration settings. This video may
pass through several networks, secure or not secure. VCS Client
gives you the option to send the video encrypted, as long as the
receiver on the other end is set to receive encrypted transmission.
It is allowed, but not advisable, to use this app without encrypted
transmission.
VCS FieldLink Support Connection:
When
you start a session, VCS FieldLink reads the VCS device's
identifier (such as its VCS number or serial number) so the relay
can route support to the correct device, and opens an encrypted
(TLS) connection to SME's relay server. While the session is
active, SME support can reach that specific VCS device's own web
and SSH management interface through this connection. The app is
only a conduit for this traffic; it does not inspect or retain the
contents of the support session. The connection is closed when the
session ends.
To operate, secure and audit the support
service, SME's relay server keeps a record of each support session:
the VCS device identifier, the device type, the phone model and
operating-system and app versions, the internet (IP) address the
phone connected from, and the times the session started and ended.
The relay also uses a random identifier created when the app is
installed so that a phone can reconnect to its own session; this
identifier is not linked to you and is not kept after the session.
Session records are used only to provide, troubleshoot and secure
support. They are not used to identify you, for advertising, or for
tracking, and they are not sold or shared with third parties.
VCS FieldLink Diagnostic Logs:
VCS
FieldLink keeps a technical log and crash reports on your device to
help diagnose problems. These logs are stored locally and are
shared with SME support only when you choose to send them (for
example, by tapping "Send app logs to support"). They are not
uploaded automatically, and they are technical diagnostics that are
not used to identify you.
Non-personal data:
SME may
use tools or third party analytical software to collect and use
certain non-personal data that does not enable SME to identify you.
The types of non-personal data SME may collect and use include, but
are not limited to: (i) mobile device type; (ii) mobile device
software version; (iii) geographical data no more accurate than
metropolitan areas (VCS Client only); (iv) total time of app usage
and usage of filters; (v) other non-personal app data as reasonably
required by SME to enhance its features. VCS FieldLink does not
contain third party analytics or tracking.
SME may use the
collected data for purposes of analyzing usage of the apps,
managing and providing VCS Client and VCS FieldLink and to further
develop SME's services and products.
Data Retention:
SME retains the information collected pursuant to this Privacy
Policy. If the collected information is no longer needed for
purposes specified in this Privacy Policy, SME shall delete all
aforementioned information in its possession. Support session
connections exist only for the duration of a session. VCS FieldLink
session records are kept for up to 90 days to operate and audit the
support service, and are then deleted. Diagnostic logs stay on
your phone until you delete the app; logs you choose to send to
support are kept only as long as needed to resolve your
issue, and no longer than 90 days.
Your Choices and Requests:
You can withdraw
permissions at any time in your device's settings, end a VCS
FieldLink support session at any time from the app, and delete the
app's local data by uninstalling it. To ask what information SME
holds about a support session, or to request that it be deleted,
contact SME at support@vcsplatform.com or (516) 360-1252.
SMS / Text Message Notifications:
When
you contact Saul Mineroff Electronics, Inc. (SME) support by
telephone regarding the VCS Platform and verbally consent during
that call, SME may send you transactional customer-care text
messages — such as your support ticket number and
confirmation that a specialist will follow up — to the
mobile number you provide. These are support notifications only;
SME does not send marketing or promotional text messages through
this program.
Message frequency varies based on your
support activity. Message and data rates may apply, depending on
your mobile carrier and plan. Reply STOP at any time to
unsubscribe, or HELP for assistance.
We will not
sell, rent, or share your mobile phone number or SMS opt-in data
with third parties for marketing or promotional purposes. All
other data categories referenced in this policy exclude text
messaging originator opt-in data and consent; this information
will not be shared with any third parties.
Your
mobile number and SMS opt-in consent are collected directly by
SME during your support call; no third party is involved in
collecting that consent. Mobile opt-in information is used solely
to deliver the support notifications you requested.
|
|